Customer: Bell Helicopter Description: Prime Contract Design Engineering awarded for the detail design engineering prototype development for a bearingless all Composite RTM Tail Rotor Flex Beam Assembly and manufacturing fabrication support of the following components:
Prime Contract Design Engineering responsibility for dynamic clearance envelope studies supporting tail rotor and flex beam assembly dynamic clearance integrity.
Bell Helicopter Composite Tail Rotor Upgrade
Composite Tail Rotor Detail Assembly
Composite Tail Rotor Dynamic Study
Special Mission Fixed Wing Prototype Kit Engineering
Customer: Hawker Beechcraft and BAE Systems Description: Engineering contract awarded to modify existing UC-35A Army ASE CMWS Kit installation for conformity on the U.S. Marine Corp. UC-35D fleet. All fabrication and kit proofing was preformed at HBC Wichita facility.
Customer: Hawker Beechcraft and BAE Systems Description: Contract engineering awarded for Kit Development and Modification Installation of the U.S. Army RC-12 aircraft for ASE CMWS conformity. Prototype Kit developed, fabricated and installed at HBC Wichita facility. Required Field Kit Installation engineering support at U.S. Army base located in Germany.
Customer: Hawker Beechcraft and BAE System Description: Contract engineering awarded for Kit Development and Modification Installation of the U.S. Army and Army National Guard C-12 aircraft for ASE CMWS conformity. All kit fabrication and installation was performed at HBC Wichita facility.
UC-35D Encore (Photo by Keith Robinson)
RC-12 King Air (Photo by Keith Robinson)
C-12 King Air (Photo by Keith Robinson)
Commercial Fixed Wing Prototype Kit Engineering
Customer: Hawker Beechcraft Corporation Description: Prime Engineering Contractor Lead for the kit development of the Extended Range Fuel Tank and the initial release of detail engineering documentation for the Wing Modification and Kit Installation on the King Air 350 ER aircraft.
Prototype manufacturing and fabrication of Fuel Tank detail components were completed at Hawker Beechcraft Blue Streak Manufacturing Dept.
Flight Testing and FAA Certification were conducted by Hawker Beechcraft Flight Test Engineering Dept. All engineering, manufacturing and flight testing were performed at the Hawker Beechcraft Corporation facility located in Wichita Kansas.
Extended Range Fuel Tank Prototype Install
Hawker Beechcraft King Air 350ER
Certified King Air 350 ER
No information on this website may be copied in part or in whole for any purpose without a written approval from an official Front Range Aircraft Modification LLC Officer. Offenders will be prosecuted to the extent allowed by law.
